Epoxy Flooring in Brighton, MI

Brighton has grown from a small village into a busy city, and epoxy flooring in Brighton reflects that range. The city had 1,287 residents in 1930 and 7,446 in 2020. Most of that growth came well before 2010, when the count was already 7,444. Housing units rose from 3,905 in 2010 to 4,001 in 2020. A Brighton garage could be a 1950s slab near Main Street or a much newer one on the city's edge.

The downtown and the Millpond

Brighton was settled in 1832, became a village in 1867 and a city in 1928. Downtown is centered on the Millpond, and the city's Millpond Park hosts a free summer concert series on the waterfront. Homes near the old center are often the oldest in town. Their garages tend to be smaller, sometimes detached, with slabs that have seen decades of salt, oil and patching.

Prep for an older Brighton slab

• Grind off old paint and sealer down to bare concrete
• Degrease oil spots that have soaked in
• Fill cracks, chips and pitted areas so the new surface is continuous
• Check for settled or heaved sections that need concrete repair first

Weather on a Brighton floor

Brighton has a continental climate, with warm summers and cold winters that bring moderate to heavy snow. Average precipitation is 29.28 inches a year. The record high is 101°F and the record low is −23°F. That range is hard on bare concrete. In winter, brine and freeze-thaw wear down the surface. In summer, hot tires can lift a cheap coating. A system with a properly ground base and a clear topcoat handles both.

Get a Free Estimate

Commercial and retail floors

Brighton Mall sits off I-96 at exit 145, and the city has a lively downtown along Main Street. Shops, service bays and back rooms all have concrete floors that take a beating. Our shop and commercial floor epoxy uses thicker builds for carts, forklifts and foot traffic. We can plan the work around business hours, and a polyaspartic floor coating can shorten downtime.

Residential systems we install

Garage floor epoxy and epoxy flake floors are the most common jobs in Brighton garages. Basement floor epoxy goes on after we test the slab for moisture, with a vapor-tolerant primer when needed. Metallic epoxy floors suit finished lower levels and home theaters.

We do not quote over the phone. After a free visit we send a written quote with the square footage, the prep steps, each coat and the total. If grinding turns up a hidden problem, we write it up for your approval before going further.

Questions to ask any floor installer

• How will the slab be prepared, and will the edges be ground too?
• Will the slab be tested for moisture first?
• What is the system, coat by coat, and how thick is it?
• When can I walk on it, move things back and park?
• What happens if a hidden crack or old coating turns up during prep?

We answer each of these in the written quote, so you can compare it side by side with any other bid.

Finished basements and home gyms

Many Brighton homeowners turn the lower level into a gym, playroom or media room. Basement floor epoxy gives a sealed surface that is easy to clean and does not trap dust. A flake finish adds texture under rubber mats and bare feet. For a more decorative room, a metallic system gives a poured, marbled look. Each one starts with the same slab moisture test.